This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:
How do you inspect underground pipes that carry contaminated waste from the inside out? It's a question the Hanford Site in Washington state has faced as it works to clean up the waste left by decades of nuclear production.
Hanford is a decommissioned nuclear production complex managed by the Department of Energy. Located on the Columbia River, it was established in 1943 as part of the Manhattan Project and housed the world's first full-scale plutonium production reactor. The plutonium produced at the site was used in the first atomic bomb.
What's left at Hanford is radioactive waste that is housed in underground storage tanks, connected by a network of pipes. These pipes are designed to transfer waste from one tank to another, but the pipes are decades old and must be inspected to ensure they are in good condition.
The pipes at Hanford are hard to access. They are underground, run hundreds of feet in various directions, are double-walled and measure as little as 2 inches (5.1 centimeters) in diameter.
Digging up these pipes for a visual inspection isn't realistic or cost-effective. It also can't ensure that pipes aren't corroding from the inside out.
While sending tiny cameras inside the pipes might seem like the obvious solution, earlier attempts had limited success.
Traditional "push" cameras used for visual inspection could travel only about 10 feet (3 meters) at a time and were unable to maneuver tight 90-degree bends.
Source link







